Yes, thinking about this, this could be a better way to go. A way of
turning off the white space above or below the header would be nicer
perhaps. It would also enable a few other things to be done easily too.
.... Yeah, a lot more flexible at the same time as being more "correct".
@ What I want to prevent is the HR being used in another way than as a
@ block separator. Something like "<H1>Hi<Hr>there</H1>" strikes me as
@ abuse, and your proposed change to the DTD would allow that.
*grin* Just tried it in Lynx and Mosaic and erm it works... or breaks so
to speak.
So what would the additional rules be then?
<H# rule=bottom> miss out whitespace under a header?
<H# rule=top> miss out whitespace above a header?
That would accomplish things quite nicely I guess. And again as usual,
backwards compatibility wont be affected. :)
Paul
.-------------------------------------------------------------------------.
|_______Paul_S._Wain,_(X.500_Project_Engineer_and_WWW/HTTP_chappie),______|
| Computer Centre, Brunel University, Uxbridge, Middx., UB8 3PH, ENGLAND. |
|___VOICE:_+44_895_274000_extn_2391_______EMAIL: [email protected] __|
| http://http2.brunel.ac.uk:8080/paul/ |
`-------------------------------------------------------------------------'